JMatPro® version 11.0 released

Version 11.0

  • addition of a new Stainless Steels solidification model

  • addition of calculation of forming limit diagrams for Al,Mg, Ni,Co,Ti 

    alloys, General Steels and Stainless Steels

  • addition of processing map calculation  for Al,Ni,Co,Ti alloys, General Steels and Stainless Steels
  • improved Al alloys strength calculation with consideration of ageing 

    and addition of Lithium contribution

  • reassessed Al alloys kinetics (impacts on TTT, CCT, isothermal and 

    strength calculations)

  • improved stress-strain curve calculations in the lower strain region

  • new model for calculation of magnetic permeability in particular at 

    high magnetic fields

  • addition of flux density in plots of magnetic permeability vs. field

  • addition of Simultaneous Precipitation calculation for maraging steels

  • addition of GUI file creation of files needed for batch calculation

  • addition of Dissimilar Metal Welds calculation for Al and Ti alloys

  • addition of Mg cast strength calculation with associated flow curves 

    and forming limit diagrams

  • addition of Fracture Toughness calculation for Al, Ti alloys and 

    tempered steels

  • reassessed thermal conductivity for high-Al steels

  • improved thermodynamic solver stability


  • new Al export for Sysweld
  • new ProCAST export for General Steels allowing different grain size for further heat treatment after casting
  • removed problematic characters in export to ProCAST
  • new expanded export for Simufact
  • format changes for export to Transvalor software
  • ensured correct decimal separator in LS-DYNA export
  • changed the way latent heat is obtained for General Steels in export to Magmasoft
  • LS-DYNA welding export extended to Al alloys
  • fixed occurrence of too many data lines in Sysweld export


  • update of Fe thermodynamic database: adjustment of CU phase

  • update of Cu thermodynamic database: addition of Bi

  • update of Al.db: adjustment of AL3M_L12 phase

  • update of Mg.db: new phase FCC_A1 (not directly used)

  • fixed possible missing point in Quench Properties calculation

  • fixed possible rounding issue in Flow Stress Analysis calculation

  • fixed possible glitches in Stress-Strain calculations
  • fixed Poisson's ratio calculation for Martensite in Ti alloys
  • fixed possible memory problem in Al kinetics calculation
  • fixed wrong labelling in tempering plots
  • fixed missing documentation
  • new Terms & Conditions of use
  • many small improvements in GUI
Keep up to date with all the conferences and exhibitions where Sente Software or one of its representatives will be present by checking out our